American Irrigation Repair
Recommended Tools
Having these items on hand can make locating and accessing your shut-off valves much easier
-
Flathead Screwdriver
(for probing grass or prying open box lids) -
Channel-Lock Pliers or Vise Grips
(for stiff or hard-to-turn handles) -
Shovel
(for locating hidden valve boxes or clearing out debris)
After-Hours Emergencies
If you cannot stop the leak yourself and it is outside normal business hours, contact your local municipal water provider immediately
Active leak?
Here are step-by-step instructions ton what tools you will need and how to safely turn off your sprinkler system and protect your property.
First Step
What You’re Looking For
-
Locations:
Shut-off assemblies are typically housed inside ground boxes (often green) or located above ground (frequently wrapped in insulation). -
Key Components:
The handles attached to the brass backflow assembly are your main shut-off controls. -
Golden Rule of Valves:
Parallel to the pipe = ON
Perpendicular (90 deg) to the pipe = OFF
Second Step
Choose Your Valve Type & Turn the Water Off
⚠️ Be Aware: Below-ground valve boxes often fill with dirt or debris
Look for a green rectangular box (typically $12 \times 18$ inches) near or behind your water meter close to the street
Lift the lid
Look inside for two shut-off valves (handles are commonly blue or yellow).
-
Lever Handles:
Turn either handle a full 90 degrees until it is perpendicular to the pipe . (Use channel-lock pliers or vise grips if the handle is stiff) . -
Circular Valves:
Turn clockwise until fully closed .
Note: Closing either valve stops the flow, but you can close both for extra security
Watch the leak to ensure the water stops flowing
⚠️ Be Aware: Above-ground valves are often wrapped in insulation or placed inside protective covers
Locate the brass backflow device near the water meter, along the side of the house, or inside an enclosure
Remove protective coverings to expose the valves
Find the two shut-off valves on the brass assembly (usually blue or yellow handles)
Turn either handle a full 90 degrees until it is perpendicular to the pipe
Allow remaining trapped water in the lines to drain out, then verify that the active leak has stopped
Double-Check the Valve handles
Ensure the handles are rotated a complete 90 degree. A partial turn will still let water pass through.
Turn Off Your Main House Lines
If the irrigation valves are fully closed but water continues running, the leak may be on your main household plumbing system rather than the irrigation setup. You may need to shut off the main supply to the entire home or turn off water at the meter.